3. Combined Parametric Model

This step of the group assignment combines the three Dynamo-Models into one model. The setup was chosen as follows:

1. The hangar is at the end of the runway-exit

2. The tunnel ends below the hangar

3. The other end of the tunnel is on the other way of the runway

The setup could represent an airplane manufacturing place with a runway to test new prototypes and a supply tunnel to be connected to the outside.

The 3D Model can be found here:

Joint Geometry G4 by gruppe4 on Sketchfab

Download: combined_parametricmodel_group4

Also check out the single models of the hangar, the runway and the tunnel.